La Gard Electronic Lock Operation

Select from one of the topics below for further information on the operation of your La Gard Electronic Lock. If you are having trouble trouble with the operation of your lock contact Superior Safe at 801-377-7199 where someone can assist you.

Lagard Lock Image
LaGard Logo
  • OPENING THE LOCK

    How To Open The Lock

    • Enter valid six (6) digit combination (factory set to 1-2-3-4-5-6).
    • The lock will confirm a valid combination entry with a double signal.
    • Within four (4) seconds, turn the handle to open position.
    • Pull door open.

     

    INVALID COMBINATION ENTRY – Lock will signal three (3) times.

     

    • Wrong Try Penalty
    • Entry of four (4) consecutive invalid combinations starts a five (5) minute delay period. LED flashes red at ten (10) second intervals.
    • At the end of the delay period, two (2) more consecutive invalid combinations will restart the additional five (5) minute delay period.

     

    ENTRY WILL NOT RESPOND TO KEYSTROKES DURING DELAY PERIOD.

  • CHANGING THE COMBINATION

    How To Change Your Combination

    ALWAYS PERFORM THIS OPERATION WITH THE DOOR OPEN

    • Enter “zero” six times.
    • Enter your existing six (6) digit combination one time.
    • Enter your NEW six (6) digit combination two times.
    • If a mistake is made, wait thirty (30) seconds and repeat
      steps 1- 3.
    • Test lock operation several times before closing the door.

     

    CAUTION: When selecting a combination do not use birthday or other predictable data that could give correlation between the user and combination.

     

    • Valid Combination Entry – Double signal after valid six (6) digit combination is entered.
    • Invalid Combination Entry – Triple signal indicates the old combination is still valid.
  • CHANGING THE BATTERY

    How To Change The Battery

    Repeated LED flashing and beeping during an opening indicates that the battery is low and needs immediate replacement.

     

    Uses one (1) 9-volt alkaline battery only. The replacement of batteries at least once annually is recommended.

     

    If battery is depleted and will not allow lock to open, follow instructions below. Lock contains a non-volatile memory, even with batteries removed the lock will retain all programming.

     

    To Change Battery

    • Slide the keypad housing up and carefully pull away from mounting surface to expose battery compartment.
    • Remove the old 9-Volt alkaline battery.
    • Remove the connector by unsnapping it from the two terminals on the top of the battery.
    • Replace with NEW 9-Volt alkaline battery. CAUTION! Hold onto battery terminal connector to avoid pulling the wires out of housing.
    • Carefully position the keypad over the mounting screws and slide the keypad housing down. Ensure there are no wires or cables trapped between the input pad and the safe door. Pinched cables can result in a short circuit.
American-Made Steel Icon

The Superior Promise

Superior Safe Company confidently makes the claim, “A Step Above the Rest.”  This is not a sales slogan, but rather our pledge to you. We stand behind this statement with our guarantee, “If you can find a better safe for less cost, Superior Safe will refund your money in full.”  We define better to mean: level of security, fire protection, quality of finish and workmanship. This guarantee is good for one year following your purchase.

Copyright © Superior Safe Company. All rights reserved.